Infrared Remote Control
TELEVISION STANDBY
PICTURE SIZE/
TELETEXT SIZE SELECTION
TUNER/CABLE NETWORK
SELECTION
MAKE THE REMOTE CONTROL WORKS
FOR TV, STB, VCR, CABLE, DVD
PLAYER
DIRECT CHANNEL SELECTION
ONE OR TWO-DIGIT CHANNEL
SELECTION/
SWITCH REPEATEDLY BETWEEN THE
LAST TWO CHANNELS DISPLAYED
TELETEXT STORE
NEXT CHANNEL/
TELETEXT NEXT PAGE
VOLUME INCREASE
TEMPORARY SOUND SWITCH-OFF
VOLUME DECREASE
EXTERNAL INPUT SELECTION/
TELETEXT MODE (LIST/FLOF)
SELECTION
PREVIOUS CHANNEL/
TELETEXT PREVIOUS PAGE
TELETEXT DISPLAY/
MIX BOTH TELETEXT INFORMATION
AND THE NORMAL BROADCAST
INFORMATION DISPLAY/
TELETEXT REVEAL
EXIT FROM ANY DISPLAY
MENU DISPLAY/
TELETEXT INDEX
CONTROL THE CURSOR
IN THE ON-SCREEN MENU
SOUND EFFECT SELECTIOND
CONFIRM YOUR CHOICE
(STORE OR ENTER)
PICTURE EFFECT SELECTION
SURROUND ON/OFF DIRECTLY
SELF FOCUS
SOUND MODE SELECTION
FASTEXT TOPIC SELECTION
PICTURE FREEZE
AUTOMATIC SWITCH-OFF
VCR/DVD FUNCTIONS;
TELETEXT SUB-PAGE
- REWIND (
- STOP (
- PLAY/PAUSE (
)
)
REMOTE CONTROL SETUP
TELETEXT CANCEL
)
- FAST FORWARD (
)
TELETEXT PAGE HOLD
IF YOUR REMOTE CONTROL IS
NOT FUNCTIONING PROPERLY,
TAKE OUT THE BATTERIES AND
PRESS THE RESET BUTTON FOR
ABOUT 2~3 SECONDS. RE-INSERT
THE BATTERIES AND TRY USING
THE REMOTE CONTROL AGAIN.
The performance of the remote control may be affected by bright light.
➢
Connecting to the External Input/Outputs
➢
EXT 1 is used for the equipment with an RGB output, such as video game
VCR
DVD
devices or video disc players.
②
③
①
Rear of the TV
or
or
Decoder /
Video game device
Video disc player
Satellite receiver
①
②
This end can be fitted with:
◆
◆
◆
A SCART connector
An S-Video connector and two audio RCA connectors (L+R); EXT 2
Three RCA connectors (VIDEO + AUDIO-L and R)
➃
If you have a second VCR and wish to copy cassette tape, connect the
source VCR to EXT 1 and the target VCR to EXT 2 so that you can redirect
the signal from EXT 1 to EXT 2.
③
➃
If you have a decoder, connect the decoder to the VCR and the VCR to the
television.
When you wish to record a programme, connect the receiver to EXT 1 and
the VCR to EXT 2 so that you can redirect the signal from EXT 1 to EXT 2.
Whenever you connect an audio or video system to your
television, ensure that all elements are switched off.
☛
Refer to the documentation supplied with your equipment
for detailed connection instructions and associated safety
precautions.
Connecting to the Audio Output
➢
The RCA (AUDIO-L and R) connectors are used for equipment, such as an audio
system (to take full advantage of the Surround sound effect).
Rear of the TV
Audio system
Connecting to the RCA Input
➢
The RCA (VIDEO + AUDIO-L and R) connectors are used for the equipment, such as camcorders,
video disc players, and some video game devices.
Side of the TV
(depending on the model)
Camcorder
Video game device
Video disc player
Connecting to the S-Video Input
➢
The S-VIDEO (or S-VIDEO INPUT) and RCA (AUDIO-L and R) connectors are used for equipment
with an S-Video output, such as a camcorder or VCR.
Side of the TV
(depending on the model)
Camcorder
①
and
VCR
①
To play pictures and sound, both the S-VIDEO (or S-VIDEO INPUT) and RCA connectors must be used.
Connecting to the Component Input
Rear of the TV
DVD
DTV receiver
➢
The COMPONENT IN connectors are used for equipment with a DVD or DTV receiver output.
(480i, 480p, 576i, 576p, 1080i)
|